Universal-G-Code-Sender
Universal-G-Code-Sender copied to clipboard
Clicking "Run From..." from the editor should ensure the controller has the current program
Version
2.0.12
Hardware / Firmware
GRBL 1.1
What happened
I spent tens of minutes trying to figure out why "Run From..." didn't work. Neither did "Send". Turns out, I hadn't saved the file. In an IDE if I say "build & run" it asks if I want to save everything first, with a checkbox to always save. That seems like much less cryptic behavior.
How to reproduce
Open a blank file, add some lines of gcode, connect, say "Run From..." or "Send". Note that nothing happens. Save the file and try again. IT works.
Operating System
macOS
Anything else
No response