smarttwc

Smart (Tesla) charging with a (EU) Tesla Wall Connector (TWC) using Python 3 code

How does it work?

SmartTWC is able to run in Master mode for a Tesla Wall Connector and by sending it messages over RS-485 it can adjust the maximum allowed current the TWC will advertise to the car.

TWCManager

A lot of credits go to TWCManager for figuring out the protocol of the Tesla HPWC.

Requirements

This code has been written for Debian Linux running on a Raspberry Pi. It could and should work on all Linux platforms, but that has not been tested.

The Python code is written for Python >=3.5 and requires a few additional libraries. These can be found in requirements.txt