Yuri D'Elia

> The compatibility condition is calculated first when the profile is saved, as it is an expensive operation. Mhh I'm not sure I follow. The profile on disk just contains...

On Fri, Feb 28 2020, Vojtěch Bubník wrote: > The way I understand you is that you have a profile that you edit, but do > not save yet. In...

On Fri, Feb 28 2020, Vojtěch Bubník wrote: > The profiles you derived from Prusa3D system profiles are considered > to be part of the space of the Prusa3D vendor,...

On Fri, Feb 28 2020, Vojtěch Bubník wrote: > While the condition may be used to check for dependencies across > vendor profiles, we made a decision to separate the...

On Fri, Feb 28 2020, Vojtěch Bubník wrote: > May I ask you what is your workflow? How many printers are you using > in the same slicer instance? How...

On Sat, Feb 29 2020, Vojtěch Bubník wrote: > The decision to make the print and filament profiles locked to the vendor > space of the printer was made to...

Whoa, I didn't expect this. I'm sorry if this came out as a demand. Since you expressed some interest, I was just trying to be more argumentative than usual in...

I'm guilty. This can be done by using `D3` to first read, then again `D3 X` to restore the dump. After restoring a reset is advisable (so that the settings...

This needs more time™

Just clone https://github.com/wavexx/volatile-highlights.el/tree/highlight-reversed, then customize `Vhl/highlight-reversed`.