CLionArduinoPlugin icon indicating copy to clipboard operation
CLionArduinoPlugin copied to clipboard

Published 20 hours ago • verified publisher icon vsch

Board is not selected

Open highjeans opened this issue 9 months ago • 3 comments

I am looking to use CLion instead of the Arduino IDE to run code on my ESP32 (It is a custom one using the ESP32-S3 chip). I added the boards.txt file that is used in the Arduino IDE to get the correct board (ESP32-S3 Dev Module). However, whoever I try to make a new sketch, the create button is disabled and I see "Board is not selected" at the bottom (see screenshot). What am I supposed to do? I was able to create a new sketch previously before I downloaded the Legacy Arduino IDE for the Arduino SDK. I am on an M1 Pro mac if that helps.

FYI I need to use Arduino not PlatformIO because the club uses it and I don't want to try anything different.

Screenshot 2024-04-30 at 17 11 02

highjeans avatar Apr 30 '24 16:04 highjeans

@vsch Sorry for the ping but I needed urgent help and I've been pulling my hair over this error for a few hours now.

highjeans avatar Apr 30 '24 21:04 highjeans

I have this issue as well.

jonnybergdahl avatar May 10 '24 15:05 jonnybergdahl

I have also this issue

simon88 avatar May 27 '24 08:05 simon88