.bin firmware does not work with CCLoader

[hexdae]

First of all thank you so much for this amazing work, this project is very well coded and a huge help for myo applications.

While following your firmware installation guide I had some troubles uploading the .bin firmware to an HM10 module using CCLoader. I found that converting the .hex to .bin and then uploading worked perfectly. I suspect there is just a small error around the convention used for 0s in the CCLoader Arduino sketch. I will upload here the zipped working firmware for anyone that wants to use it right away MyoBridge_CC2541 for CCLoader

I am making this comment only to help to troubleshoot for other users that might have the same problem. Keep up the good work.

EDIT: This is by uploading with the MacOS version of CCLoader

[vroland]

Thanks! I think I will just leave this open for now...

[umaires28]

First of all thank you so much for this amazing work, this project is very well coded and a huge help for myo applications.

While following your firmware installation guide I had some troubles uploading the .bin firmware to an HM10 module using CCLoader. I found that converting the .hex to .bin and then uploading worked perfectly. I suspect there is just a small error around the convention used for 0s in the CCLoader Arduino sketch. I will upload here the zipped working firmware for anyone that wants to use it right away MyoBridge_CC2541 for CCLoader

I am making this comment only to help to troubleshoot for other users that might have the same problem. Keep up the good work.

EDIT: This is by up

First of all thank you so much for this amazing work, this project is very well coded and a huge help for myo applications.

While following your firmware installation guide I had some troubles uploading the .bin firmware to an HM10 module using CCLoader. I found that converting the .hex to .bin and then uploading worked perfectly. I suspect there is just a small error around the convention used for 0s in the CCLoader Arduino sketch. I will upload here the zipped working firmware for anyone that wants to use it right away MyoBridge_CC2541 for CCLoader

I am making this comment only to help to troubleshoot for other users that might have the same problem. Keep up the good work.

EDIT: This is by uploading with the MacOS version of CCLoader

sir i am working on this can we use the HM-10, Bluetooth module using TI CC2540 chip instead of HM-11 for connecting myo directly to arduino without any bridge(laptop). and please guide me will this all procedure work fine and connect the myo arm band directly to arduino thanks sir

[yunus72]

Hi first of all thanks for your work. I did all directives and uploaded successfully CC2541hm10v540 firmware to my bluetooth modele but sill can not find any myo device just says Searching for Myo... How can i fix this issue any idea ?