OctoPrint-Enclosure
OctoPrint-Enclosure copied to clipboard
vitormhenrique
OctoPrint Enclosure Plugin
Hi vitormhenrique, I am using octoprint on a Raspberry PI 2B. With GPIO 23 I control a lamp via pwm.  After I have saved the configuration, I can dim...
I have a Raspberry Pi 4 wired up to an Adafruit BME680 board over the 4 cable quick connector, connected like this  But I am not able to get...
**Is your feature request related to a problem? Please describe.** A clear and concise description of what the problem is. Ex. I'm always frustrated when [...] ...the print stops because...
Hello guys, After trying pretty much everything I still can't get the sensor temp to display. I have already tried disabling the use SUDO box. The libraries are installed and...
Added temperature sensor support for Adafruit 2101 Added output support to change fan speed on Adafruit 2101
Lightweight hardware PWM implementation with GUI configuration, allowing 25000 Hz PWM signal suitable for controlling Noctua PWM fans. Another PR #442 but was criticised for needing pigpio and lacking UI...
The plugin worked perfectly after initial installation but then the following day none of the buttons work. They are there on the Nav bar and in the plugin tab but...
**Is your feature request related to a problem? Please describe.** I have a SnapMaker 2.0 A350 with their enclosure. The enclosure has built in lights and an exhaust fan controlled...
This pull will fix issue #349. I've been testing this since December and have received positive feedback from @ahmaddxb and @ni-aakerman.
Hello Guys, after a while of researching, I'm still not able to get the Enclosure Plugin to run. It alwasy fails with the Messages underneath. My Enviorment is: Octoprint Version...
