OctoPrint-Enclosure
OctoPrint-Enclosure copied to clipboard
vitormhenrique
OctoPrint Enclosure Plugin
**Describe the bug** Once a temperature alarm is setup as input display of temperature sensors in enclosure tab is not working for any sensor. Also the set up alarm does...
The gcode control for regular outputs is ENC O[id] S[value] When doing ENC O[id] without the S value it turns the value to off. Could you do ENC O[id] T...
Just installed enclosure plugin, and am running switch that is 5V when filament is in, GND when out. Enclosure picks up the signal and executes my output, which does the...
Hello, I'm sorry to hear about your broken arm. I hope recovery is as quick and painless as possible. I am using the Qrome printer-monitor that utilizes a Wemos board,...
It's very cumbersome to configure the plugin when you have multiple inputs and outputs. It turns into a long confusing to navigate single vertical list. It would be a lot...
**Is your feature request related to a problem? Please describe.** No problems per se, just wanting better performance **Describe the solution you'd like** Implement a PID feedback loop for fans...
You may want to include the python-setuptools package in the read me section for the Adafruit temperature sensor installation.
Hi, An issue occured and so far I haven't been able to solve it. Could somebody help me to find a solution ? I use Octoprint 1.4.0 with Enclosure plugin...
Describe the bug Once a temperature input is setup i can't have it display on navbar although i can collect a reading trough SSH terminal command cat w1_slave. What Am...
Hello, I'm in somewhat of a unique position. I'm using a Pimoroni Hyperpixel 4.0 display, which uses all of the GPIO pins for the display, making all of the regular...
