visualvalhalla

User error - maybe. I see only Upload to SD is support. Closing issue

Attached gcode sliced from this stl: https://www.thingiverse.com/thing:2197230 [D3_Latice_torture_test_2.zip](https://github.com/Mrnt/OctoPrint-FlashForge/files/5148186/D3_Latice_torture_test_2.zip)

rebooted printer, connected Octo to printer. Fan on/off works. Tapping LEFT and DOWN arrows moved the print head in the expected directions Send: G28 Recv: CMD G28 Received. Recv: ok...

I have debug logging turned on for octoprint.plugins.flashforge but I don't see any log files

[octoprint.log](https://github.com/Mrnt/OctoPrint-FlashForge/files/5148223/octoprint.log) Debug on. G28

[octoprint (1)_attempt to print.log](https://github.com/Mrnt/OctoPrint-FlashForge/files/5148226/octoprint.1._attempt.to.print.log) Right after that, I attempted to print to print the gocde that was attached earlier

Yes, I tried combinations of X Y and Z.... head did not move at all

[octoprint _G28_test.log](https://github.com/Mrnt/OctoPrint-FlashForge/files/5148305/octoprint._G28_test.log) Confirm the head is in the middle of the plate. No movement observed

Would sniffing the USB comms between a PC and 3D45 help?

I've not tried the direct USB route yet to print. I use network connection to the printer. The Dremel slicer does not have controls other than print.