6wire Square Pump Model S100104

[there707]

I've done exactly what others have done for square model S100102 but I cannot get buttons or GUI to work. I do get current temperature, temperature SP, brightness slider and the ESP reset button but that's it.

• PCB_V1
• Removed TXS1008Eand jumpered A1, A2... to B1, B2...
• added 10K resistor
• added and removed 680ohm resisters on display connector

Is my S1000104 that different?

[menime8]

Your display plays the funky sound at startup? Then you see the IP adress and actual date?

Set PCBV1 in program? Select Miami2021 in model.h?

[there707]

Yes on both questions.

[visualapproach]

Yes on both questions.

There are 4 questions...

[menime8]

You have the same problem like me. At the moment i can´t figure out what is wrong. Which ESP you have? ESP8266MOD?

[there707]

Yes on both questions.

There are 4 questions...

Sorry, yes on both lines of questions

[there707]

You have the same problem like me. At the moment i can´t figure out what is wrong. Which ESP you have? ESP8266MOD?

I'm not familiar with ESP8266MOD, but I refer to my as a NodeMCU

[menime8]

What Version of CIO board you have? You find it bottom right corner.

[air101]

Try a different NodeMCU, see my problem here: #325

[there707]

Now going to look at https://github.com/visualapproach/WiFi-remote-for-Bestway-Lay-Z-SPA/issues/325

[visualapproach]

#330

[there707]

#330

Just got back to this, thanks @visualapproach this worked. PCB_V2B, red LCC, no resistors or caps and wiring per @Sigmapic