comfoair-esp32
comfoair-esp32 copied to clipboard
vekexasia
Interact with Zehnder Comfoair with esp32
Hi, Just finish the wiring my ESP32 to a Zehnder Comfoair Q600 premium. The communication seems to work as i receive some value. But the comfoair show '' error on...
My MQTT broker gets a lot of unnecessary information: each second "next_fan_change" and "exhaust_fan_flow", "exhaust_fan_speed", "supply_fan_flow", "supply_fan_speed", "power_consumption_current" and "avoided_heating_actual". As the changes are only minimal (+/- 1 m³/h, 5...
Hello, I make various pcb boards and I have a proposal to make a professional board for this project. I wanted to add MQTT broker control over ETHERNET, is it...
Hi I just upgraded to the ESPHOME version. When I send the command 'auto' the unit doesn't seem to respond. I am able to set other settings like e.g. :...
Trying to send any command (fan speed, temp. profile etc.) reports following errors in the log: [W][component:204]: Component api took a long time for an operation (1.00 s). [W][component:205]: Components...
Thanks for your great work! Is there a HEX command that can be used to force the ComfoAir to send all data, including bypass state and percentage? When my Home...
While digging into the esphome component I tried to compile. Whenever I add the connection pins the compilation will stop running with the following error: ``` Compiling .pioenvs\esp32-mqtt-zehnder-kd\libd8f\noise-c\protocol\symmetricstate.c.o Compiling .pioenvs\esp32-mqtt-zehnder-kd\libd8f\noise-c\protocol\util.c.o...
Hello, I have a question about the entity state after ESP reset. All entities are in an unknown state until they are replaced or updated. Is there any way to...
Hi, I have an ESP32 from node mcu (see the figure below for the pinout and the board specifics. I think the pinout is not exactly the same as what's...
Does this project also work with a ComfoAir70. It doesn't support the LAN C Adapter but works with a RF + Connect box. Connection via Bus is available (A,B, +...
