hass-aarlo
hass-aarlo copied to clipboard
twrecked
Cameras never go to idle
We don't start streams unless asked to, can you send me some debug so I can see what is going on?
Thanks
On Tue, Jan 7, 2025, 15:44 PhilipMGio @.***> wrote:
Cameras stuck on streaming witch drain battery
— Reply to this email directly, view it on GitHub https://github.com/twrecked/hass-aarlo/issues/1027, or unsubscribe https://github.com/notifications/unsubscribe-auth/ALHJU6WV22GCYVBXUSNAWVT2JQ4BZAVCNFSM6AAAAABUYPSRT2VHI2DSMVQWIX3LMV43ASLTON2WKOZSG43TGNZQGE4DOMI . You are receiving this because you are subscribed to this thread.Message ID: @.***>
Yes you are right, i start a stream then close the window feed. But the condition never goes to idle it is stuck att streaming unless i maually force it to idle.
How do i send you debug?
This may be something I can look at. Is this the Lovelace component?
On Tue, Jan 7, 2025, 15:55 PhilipMGio @.***> wrote:
Yes you are right, i start a stream then close the window feed. But the condition never goes to idle it is stuck att streaming unless i maually force it to idle.
How do i send you debug?
— Reply to this email directly, view it on GitHub https://github.com/twrecked/hass-aarlo/issues/1027#issuecomment-2576202472, or unsubscribe https://github.com/notifications/unsubscribe-auth/ALHJU6TTHAM7D2DR5XM662L2JQ5KXAVCNFSM6AAAAABUYPSRT2VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDKNZWGIYDENBXGI . You are receiving this because you commented.Message ID: @.***>
I can confirm this also happens with my older VMC3030 with the latest Coe update of 2025.1.1 fro yesterday on Arlo firmware 0.8.1.11. Was fine prior.
Just an FYI… I had a streaming error for that specific camera that showed up in my logs. I accidentally cleared my logs trying to copy and paste that into this forum so you could see it. For some reason, I cannot find it in the raw logs. But, it was something like a stream error being initiated and I did not stream the camera. If it shows up again, I will paste it here.
I did a couple of things to combat this. I added a button on my cameras page to stop streaming. I also added an automation that will stop streaming if any of the cameras were steaming for 2 minutes.
