SimpleOpenNI icon indicating copy to clipboard operation
SimpleOpenNI copied to clipboard

Published 20 hours ago • verified publisher icon totovr

Anyone could get it working on Windows 10

Open rossanag opened this issue 5 years ago • 2 comments

Hi everyone, even it is said that it wasn't tested on Windows, it is supposed to work. I installed the plugin following all the instructions without luck. It seems the device isn't detected. Any advice about the driver I should install? I can run ofxKinect example addon with openframework, so it seems I have the right driver, anyhow I want to know if SimpleOpenNI uses some driver in particular. If anyone could get it working on Windows 10 I appreciate if you share the steps followed. Thanks!

OS: Windows 10 64 bits Kinect 1v1 414 Processing 3.5.3

rossanag avatar Jul 27 '19 05:07 rossanag

@rossanag Are you getting the blank screen?

mrsahabu avatar Dec 05 '19 12:12 mrsahabu

Hi @mrsahabu actually at first I get the blank screen and just a few seconds later it becomes red. I have no error messages though, just a red screen. Below there is a screenshot of what is happening to me. On a side note, I could get it working on Ubuntu 18.04, 19.04 and 19.10 after a little tweak I mentioned here : https://github.com/totovr/SimpleOpenNI/issues/24 I tend to think that is something related to the driver. If you have any thought regarding this I will be very grateful.

kv1

rossanag avatar Dec 06 '19 04:12 rossanag