Holes and Nut Traps

[jacksonliam]

Firstly, Great Case! Just some minor issues with the screw holes.

Also the readme could do with a BOM for which nuts/screws are required.

The lid has really shallow nut traps on the bottom which I don't think are required and cause arifacts below the holes.

The nut traps on the bottom of the base are very shallow. Is this intended? The slimest nuts I know of are 2mm. Its usual to put a solid layer between the nut trap and the hole otherwise the nut trap will be filled in when the printer tries to print the perimeter of the hole and will cause print artifacts in doing so.