Torsten Kurbad

> Disabling the `contactinteraction` does remove those phantom cards, but enabling it again just brings them back. Would I need to clear some data from the app directory or DB?...

We are having/seeing the same issue here. Our setup is also LDAP-centric and the user mentioned in the logs doesn't posess the necessary privileges.

@ruedigerkupper Do you have the LDAP extension enabled for the CLI-Version of PHP as well? That was the culprit for us. Edit: Nevermind, this didn't solve the problem.

Well, that was fast. I relayed the info to Jim. I hope this will get him further along the Fusion 4 development.

Thank you for replying so quickly. Yes, I can see the problem with the connector placement on the Z-turn board vs. the 060 socket. What I really like about your...

My PCBs arrived today. Looking good! Before I can start building the first sample, we'll have our family vacation. Assembly will start at the beginning of September.

@exocyt0sis Unfortunately, in its current form, the card doesn't fit the A3000 physically. But I agree with you that the design per se is a (probably much) better choice for...

> Do you need H/V syncs for both? Would need care picking the second HSYNC pin. I guess so, yes. Both, AGA and RTG cards usually need H- and V-Sync....

Thinking further, for this setup, even a config option might be overkill. A device could be set into slave mode by putting a jumper across SCL-SDA (or somewhere else, if...

Yes, I2C has the additional benefit of being a open drain bus by default, so - in theory - you could drive more than one slave from a single master....