TJ Horner

Hi! Yes, at minimum you would need to make the +5V and GND match the pinout on the Upsy Desky. The pinout is available [here](https://github.com/tjhorner/upsy-desky/wiki/GPIO-Pinout). I would also make sure...

The protocol is indeed different. Someone else has reverse engineered the protocol the Autonomous desks use and posted their work in this repo: https://github.com/Stefichen5/AutonomousControl I do plan on adding official...

Interesting, could you verify that the +5V and GND lines are on the correct positions? You can find the RJ45 pinout [here](https://github.com/tjhorner/upsy-desky/wiki/GPIO-Pinout). If they aren't in the correct place, you...

@seanford I recommend getting an RJ45 breakout board [like this one](https://www.amazon.com/Treedix-Connector-Breakout-Compatible-Unassambled/dp/B08HGS5G8N) so you have somewhere to attach multimeter leads. Then follow this guide: https://github.com/tjhorner/wifi-desk-controller/wiki/Desk-Compatibility Basically, just use a multimeter to...

Hi, the steps for verifying compatibility are here: https://github.com/tjhorner/wifi-desk-controller/wiki/Desk-Compatibility

Thanks for the detailed report! I can make a separate decoder which offsets the height by -72 cm and send that to you for testing. I'll let you know when...

Hi @murraythegoz, sorry for the delay. A lot on my plate right now! I should have a firmware for you to test this weekend.

Definitely on the roadmap! Will need an adapter cable as noted in #5.

@Jolanrensen It's so the automation is more responsive. The state is published less often than the height is read.

:+1: Disabling the extension is a workaround for now