chris Newman

They did change something a few years ago. Minimum segments for G2/G3. Better for small arcs. (#13466) so it must have been though of.

Great, they should work then, someone else had layer shifting being caused by they think G2 and G3. I will give it some testing. On Tue, 16 Feb 2021 at...

Well done on showing the benefits of AcrWelder and also of using the latest Marlin updates, with data like this action should be taken and released ASAP by the team....

It could all be handled externally if the controller would send an informative message out the serial port. Octoprint all ready will notify you of the print finished via pushbullet,...

The problem at the moment is if you are running Octoprint on the Snapmaker 2.0 and you run out of filament it just keeps printing, the filament run-out detection does...

A few people are having the same problem and its mentioned in a few areas, here is one https://community.octoprint.org/t/snapmaker-2-0-a350/27455 [image: image.png] I will do some testing when it finishes the...

There are some more comments here. https://forum.snapmaker.com/t/sm2-0-no-filament-runout-with-octoprint/6725

I tested the filament runout and it works ok if the file is sent to the screen and recovers ok. would be better if it wiped the purge off. If...

I think we need this part of Configuration_adv.h uncommented. 

We just want the marlin firmware in the firmware to send out a message, using the host action commands that Marlin has would be great. It's then up to the...