thomaskilian
thomaskilian
Mac OS 10.15.6 (19G2021), latest download here. When compiling with build.sh it ran quite a couple of minutes until it stops at above message. Below is the last part of...
I added a LM358 from the V_Linear library, but it does show only a single OpAmp.  although a 2nd part is defined within the lib: 
I wonder if there are any pointers on how to attach a servo? I know that M280 is not supported (because it's a > 255 code) but would not mind...
I was puzzled why Teacup echoes 144 after a M400: > 2018-10-17 11:19:08,262 - Send: N32239 M400*46 2018-10-17 11:19:08,319 - Recv: E: Bad M-code 144 Well, obviously it assumes the...
I can't run the configtool.py on my Mac (no input possible; I don't want to go through that Python version hell to find the wx-issue). Anyhow, I tried to generate...
I'm using OctoPrint and found that while waiting for the bed/ext to heat up it got no temperature feedback. So instead of just posting "Waiting...." there's now the current temperature...
Is there a reason why M117 is not implemented? Cura does put them in the generated code. So why not just accept this M-code and skip the rest of the...
It looks like heater and bed use the same (default-) PID values. That does not make much sense since they have quite different physical behavior and thus demand individual settings....
I wonder if it's possible to configure the FW for 2 Z steppers?
### The problem See the issue [https://github.com/home-assistant/frontend/issues/12349](url) where I posted the details already. Basically the status is set to Exceptional when it's bright day. Night and rain are shown normally....