Timothy Miller
Timothy Miller
I did not explicitly enable fuse when creating the array. However, if there's a global setting, I think I may have changed it from the default based on advice to...
It looks like you intersected the extrusion with a cube in order to flatten it. That's a fantastic solution. And it solves some problems I encountered in the slicer. Thank...
I can't find a global setting for this. But by default, whenever I create a Draft Array, Fuse and Link Array are both set by default.
The obvious workaround is to draw a triangle that is not attached to the external points and then make each triangle vertex coincident with a corresponding external point.
I loaded this design into 0.21.2, and it has the same problem. I have actually tinkered with trying to trick the sketcher into not closing a wire by making endpoints...
The array is not expanded. And at no point did I toggle the array elements before. Otherwise I'd have noticed and figured out something about toggling it again. Toggling the...
It turns out that I didn't have enabled the option "Write out curves in parametric space of surface." It may be that my model is some kind of corner case...