Terje Io
Terje Io
> I have connected a wheel (100 pulses/rev) to an Arduino which sends exactely these commands on the serial port. So you simulate keypresses directly with the handwheel, not sure...
> PS. would it be possible to change Feed rate and distance buttons to / * and + - buttons, this way simple and cheap numpad can be used as...
> The "Highlight completed cuts" option cannot be set. How can this option be set? Currently only by editing the App.config file (RenderExecuted tag). However, I have delibaretely not enabled...
Settings `$50-55` is only available if the keypad plugin is compiled in, if not keyboard jogging feedrates are set in the _Settings: App_ tab. New is that continuous keyboard jogging...
> The settings from the UI Jogging differs from my keyboard jogging. Keyboard Jogging uses 200 mm/min, 500 with "shift" and 100 with "ctrl". A bug?, I'll have to check...
Can you try the [latest edge version](http://www.io-engineering.com/downloads)? There was a bit of code missing in the XL build.
> Do you have any plans to add macro support to IOSender? There is already and if you [enable expression support](https://github.com/grblHAL/core/blob/master/changelog.md) in the controller you have access to [system parameters](http://www.linuxcnc.org/docs/html/gcode/overview.html#_parameters)...
> but also that should be a subset of the macro capability as it is limited and a model from the distant past Well, it is part of the NIST...
> Stop button behaviour not as expected: In the program streaming state first pressing of Stop stopped to streaming G-code, but allow controller to complete all commands from planer buffer....
> Ok - Could you rename Stop button to reflect real behaviour "Pause" when streaming, "Stop" when on pause. This would be for legacy Grbl only, perhaps easy to add....