TMCStepper icon indicating copy to clipboard operation
TMCStepper copied to clipboard

Published 20 hours ago • verified publisher icon teemuatlut

Create moveByUART.ino

Open KonstantinKalinskiy opened this issue 3 years ago • 2 comments

Please add this example. It shows how to move motor only by UART communicaton. Connecting STEP/DIR pins is not necessary

KonstantinKalinskiy avatar Oct 26 '22 12:10 KonstantinKalinskiy

Nice one! Do you know of any stepstick type that have this address pin available? Would need to control 7 or more via UART.

SLAVEADDR: These eight bits set the address of unit for the UART interface. The address becomes incremented by one when the external address pin NEXTADDR is active. Range: 0-253 (254 cannot be incremented), default=0

artmekab avatar Jan 27 '23 10:01 artmekab

Nice one! Do you know of any stepstick type that have this address pin available? Would need to control 7 or more via UART.

SLAVEADDR: These eight bits set the address of unit for the UART interface. The address becomes incremented by one when the external address pin NEXTADDR is active. Range: 0-253 (254 cannot be incremented), default=0

unfortunately no. according to documentation tmc2209 has 4 addresses in UART mode

KonstantinKalinskiy avatar Jan 27 '23 10:01 KonstantinKalinskiy