teachingtechYT.github.io
teachingtechYT.github.io copied to clipboard
teachingtechYT
I have a printer that currently uses a Volcano hotend with a 1.2mm nozzle, and it would be great to use the tool to help calibrate it, as I also...
Hey Team Teaching Tech. Not totally clear if it's ok asking for help with a specific issue here or not, if not please accept my apologies and close the issue....
Same calibration for Klipper is straight forward, just enter the following in the command line: `PID_CALIBRATE HEATER=extruder TARGET=200` when it's finished `SAVE_CONFIG` for the bed: `PID_CALIBRATE HEATER=heater_bed TARGET=60` when it's...
I'm trying to do the tempure Turning but my printer is not attached to my printer. I am currently using Creality Print as my slicer, when I open the G-code...
I'm trying to go through the Calibrations on a Sovol SV08, entering the commands into the Console via the web interface. Seemingly none of the M## commands works as it...
On the [extruder calibration (e-steps) calculator](https://teachingtechyt.github.io/calibration.html), there is a calculator form. Inputting the following values: * Previous E-steps as reported by M92: `100` * Measurement between extruder entry and mark...
