tgFX
tgFX copied to clipboard
synthetos
A GUI controller for the TinyG motion controller.
On the GCode Tab- Both the Serial Port dropdown box and Clear buttons seem to be hard to 'activate' - the click area that actually selects the action can be...
tgFX build 3009 (Linux) With Xmax set to 180mm, I reset my Ymax to 40mm to see better detail on a small engraving job. To My surprise, the Prevue box...
Running build 3009, both Linux and Win7_64 On GCode Tab, when cursor is in the Draw PreVue bounding box: Linux - White cursor on black background Win7_64 - Black cursor...
Running Build 3009 on Linux, have seen same on Win7_64: The Debug button toggles between 'Enabled' with a faint background and 'Enabled' with a bold background. On Same Tab, 'Draw...
It is unclear how to label something an enhancement request - perhaps the moderator does that. It would be really helpful if the info that appears in the scroll window...
tgFX build 3009 Running Win7 64 bit Process does not exit(close) if Window closed while connected to TinyG (i.e., forget to Disconnect). Must then manually kill with Task Manager before...
I observed this first, I believe, on build 2876, continues on 2944, 2945 and 3009. When TinyG is reset, either manually or by command from TinyG command line, tgFX toggles...
For the next update.I think you can make it run on the Raspberry Pi or Beaglebone Black Is it the usb driver on Linux now is a problem?I have no...
 The main tabs are clickable and highlight only on the bottom half (as highlighted in red). Running version .96 build 2,402 on OS X 10.8.5.
When resetting to hardware defaults button is pushed the GUI will no longer draw the 2d preview until you disconnect and reconnect.
