Holes on rounded corners

[ZeroZeroOne-dev]

Currently when you have holes in rounded corners they can get cut off even if there is enough material.

Is there a way to position the hole better?

[swill]

Sorry for the delay getting back to you.

You are correct. Right now I don't have a way to move the holes back towards the inner corner. The current logic places the hole half the width of the edge width. With this logic, it does not account for cases with larger radius on the corners.

The only way to move the hole over so it is not cut out, is to increase the edge width. I could look into another parameter to offset the holes toward the inner corner, but I am not sure when I will have time for that.

here is an example of a plate that would have enough meat on the edge with the current logic.