GRBL-Plotter
GRBL-Plotter copied to clipboard
svenhb
A GCode sender (not only for lasers or plotters) for up to two GRBL controller. SVG, DXF, HPGL import. 6 axis DRO.
$settings
Project: cartesian line-up of two Y-axis/2NEMA - one X-axis/1NEMA - Z=servo S90 - Arduino Uno + CNC shield V3 - NC limit switches on X + Y - limit switch...
 May I ask how to set the tool table above the Y-axis? After setting, the pen position in the tool table is negative, and all the tool...
**Describe the bug** Before I describe the bug, I know standard GRBL cannot control 4 axis simultaneously. My board is MKS Tiny Bee with FluidNC (apparently works great with this...
Hi, When i start the 4D A tangential machine, A axis rotates correctly in linear shapes, but in curved shapes it rotates differently than the simulation. What is the reason...
Hi. As a plotter I have > 10 000 lines/figures. Software simplified it to 10 000 figures. My question - can I get total path length?
Thanks for what you have done so far. I was checking the steps for camera setup in https://grbl-plotter.de/index.php?id=form-camera and I found out setting offset in the version that I have...
Hi there, if i want to try reverse selected path, so tool go originally from up to down and I want to reverse it - start down and go up:...
I managed to enable HiDPI settings in the project, but looks like the whole forms layout should be updated, otherwise fonts are too big on my 150% DPI scaling settings....
I try to understand how Z Axis Pen Up/Down works I have stepper 24 BYJ 48 12V. When I press Z jogging 10z motor moves a little next stops and...
I made tangential knife for cutting and now have some strange issue. I open the SVG file in GRBL-Plotter and it generates g-code. G-code for first figure generated cutting direction...
