Sven337

Not stale, still intending to fix at some point

It's really just a mapping problem, see my comment above https://github.com/Koenkk/zigbee2mqtt/issues/16961#issuecomment-1615738365 Use "auto" in Z2M it means "heat" on the device. This needs a fix in Z2M but it's only...

I'd assume anything from the company will work the same way yes. If it does not work right out of the box, sniff the Zigbee traffic, I may be able...

I should note, this device also mis-reports the target setpoint as the room temperature. It may need a Z2M quirk.

Mine is always on ON also, but it regulates at a low temperature. Then I use CMD+ON to force a burn when needed.