Sander Vanheule
Sander Vanheule
It would be good to know how much of this caries over to the JG927A, so perhaps these changes can go into the base dtsi for JG927A/JG928A. Looking back at...
Looking at the [HPE 1910/1920 u-boot sources](https://svanheule.net/switches/gpl_source_drops), the JG928A should have the mode LED on the RTL8231 at gpio 8. See hpe-1910-uboot.tar.gz : v2r1_copyright/board/smb/hp1910_public/smb_public.c
> At least with the old RTL8231 gpio driver I couldn't find an RTL8231 on any address on JG927A. The bootloader sources also seem to indicate this. It will read...
> I haven't figured out how the RPS led is set. I realized I had a JG926A in storage, which also has an RPS LED. I probed the board a...
Did some more buzzing on the JG926A's RTL8231 GPIOs: - GPIO 7, 8, 9: Appear to be some kind of board ID. Strapped to ground on the PoE board -...
I reworded the fan commit a bit and merged it to main. Just the button and LED commit remaining then.
The last patch is still open, which has some unresolved comments on the LED config.
@Borromini Thanks for testing and reporting the Makefile issue! I've amended the commit.
I'll have to give it a spin too. Might take a few days before I get to it.
The issue might be that the image exceeded the original firmware partition size, causing it to be truncated. So this would depend on the size of your build. We would...