SuperSlicer
SuperSlicer copied to clipboard
supermerill
Supports are great at horizontals, horrible at any other angle.
What happened?
Hi. I'm a long time user of superslicer and i was able to tweak it almost perfectly to my requirements.
The only issue left is supports that are just too far from the model at any angle between 1-85 deg. ( pic added ).
Makes my models look really bad when i need supports at an angle ( the only thing I'm missing from cura is three supports which are just bad ass ).
i have tried to reduce the distance between top\bottom supports-model but no luck. only works for flat surfaces.
Project file & How to reproduce
just turn supports on
Version
2..4.58.3
Operating system
win11
Printer model
modded cr10sv2pro
Have you tried a finer layer height in these regions so that the stepping is less? Perhaps then the support will be close enough?
Have you tried a finer layer height in these regions so that the stepping is less? Perhaps then the support will be close enough?
i did not but i dont think this will do. im printing at 0.15 layer, 0.4 nozzle, nothing crazy.
You should also adjust the xy separation value. The normal values are ok for up/down but when slopped it in effect pushes them further away. Same in PS.
You should also adjust the xy separation value. The normal values are ok for up/down but when slopped it in effect pushes them further away. Same in PS.
Oh yeah, forgot about this myself, lol
You should also adjust the xy separation value. The normal values are ok for up/down but when slopped it in effect pushes them further away. Same in PS.
That is most likely the missing key. I was set at 350%. Trying with 25% and will update! Thanks a lot.
I think an option to prefer the Z offset over the XY offset for interfaces would be great
I am having the same issue supporting the bottom of a "Bowl" shaped object. Not only does it look awful, I think the distance (Mine is set to .2) is not being obeyed and the support structure was very very firmly attached to the bottom.
