Since there isn’t a discussion tab… THANKS!

[Rick88Stang]

Printed the right mount and it works great with the clockwork 2! Printing like a beast! The only thing I’m struggling with is the offsets for the placement of the nozzle. Are you adjusting the min x & y settings in marlin? If so what have you used that works best for you. Thanks for your hard work!

[strayr]

I'm using klipper, but yes you need to adjust the endstop position and bed size in marlin.

I also move the Y extrusion forwards, just using the front screws in the base into the rear holes in the extrusion and some shorter screws and t-nuts for the other two.

This is fairly standard for ender3 mods, and the nozzle ends up in about the same place in Y it is on a full switchwire conversion.

On Wed, 27 Jul 2022, 21:15 Rick88Stang, @.***> wrote:

Printed the right mount and it works great with the clockwork 2! Printing like a beast! The only thing I’m struggling with is the offsets for the placement of the nozzle. Are you adjusting the min x & y settings in marlin? If so what have you used that works best for you. Thanks for your hard work!

— Reply to this email directly, view it on GitHub https://github.com/strayr/voron-afterburner-ender3/issues/3, or unsubscribe https://github.com/notifications/unsubscribe-auth/AKIYU2HHZJ5LYRYFSVJKNGLVWGKFDANCNFSM54234EVA . You are receiving this because you are subscribed to this thread.Message ID: @.***>

[acesyde]

Hi @strayr thank you for this adapter, can you share your klipper configuration ?

[strayr]

My macros are here https://github.com/strayr/strayr-k-macros

Snapshot configs from when various printers have been working well are here.

They're likely different in some way to anything you're running and might not be appropriate to get started.

https://github.com/strayr/sample_klipper_configs