strayr-k-macros

strayr-k-macros copied to clipboard

Shutdown TMC driver reports error

10

Trying to use mechanical level So after typing g34 The gantry homes goes all the way up does the crash as expected and after lowering slightly it pauses then klipper...

karlc28

Mechanical gantry level spread cycle vs stealth chop behavior

1

I have observed that the mechanical gantry calibration works best with stealthchop enabled. At the default .12 A current, spread cycle cannot lift the gantry and result in it falling...

mneis1

Auto-power off printer when connected to wifi power plug

2

Thought it would be a good addition to your macro-set. my printer is connected in a tp-link wifi power plug (you can use anything moonraker supports). this will; auto turn-off...

stephbellemare