When creating software RAID, one is unable to chose the mount point

[maxlevesque]

Hi, Thanks a lot for this wonderful tool I've just discovered. It would be useful if one could chose the mount point of a software RAID during or after its creation. All the best !

[vojtechtrefny]

Hi, I've just checked and I am able to set a mountpoint when creating mdraid in blivet-gui in Anaconda. What version of Fedora are you using?

[maxlevesque]

Hi, I'm using Fedora 25. By Anaconda, you mean in the Fedora Installer, don't you? What I tested is the standalone program installed in Fedora 25 after installation by sudo yum install blivet-gui followed by sudo blivet-gui.

[vojtechtrefny]

Blivet-gui currently doesn't support mountpoint configuration (because blivet doesn't support it).

I was asking about Anaconda because in Fedora 26 blivet-gui will be part of Anaconda -- https://fedoraproject.org/wiki/Changes/AnacondaBlivetGUI -- and mountpoint configuration is actually supported there but only to tell Anaconda to use the newly created partition/raid/lv as e.g. /home

[maxlevesque]

Many thanks for your answer. And thanks for blivet-gui !

Le 23 mars 2017 11:48, "Vojtech Trefny" [email protected] a écrit :

Blivet-gui currently doesn't support mountpoint configuration (because blivet doesn't support it).

I was asking about Anaconda because in Fedora 26 blivet-gui will be part of Anaconda -- https://fedoraproject.org/wiki/Changes/AnacondaBlivetGUI -- and mountpoint configuration is actually supported there but only to tell Anaconda to use the newly created partition/raid/lv as e.g. /home

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/rhinstaller/blivet-gui/issues/45#issuecomment-288681897, or mute the thread https://github.com/notifications/unsubscribe-auth/ABu-48lFoxanuCvEHcZ5cq5XMf8Bf2Moks5rok37gaJpZM4Mj2wp .