Stefan Kalscheuer
Stefan Kalscheuer
Anything wrong with `4MAXP2_DGUS_BLT_10_v1.5.4.hex` from the [Releases](https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/releases/tag/1.5.4) page? `_BLT` is self-explaining here and 0.0.2 mainboard "behaves like a Trigorilla 1.0", so should run fine with `_10` flavor. (see https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/wiki/Beginner's-Guide-(English)#4-download-the-correct-firmware)
Weird 🤔 Both mages are built from the same source code in the same pipeline, so I’d expect both showing the very same issue or none. Seems like this config...
I got a question according your wiring: Was there anything connected to the Z+ pin before you connected the BLTouch? The code indicates that "Z+" (D19) is used for Y...
> HOMING End location:Â when homing, now the hot end goes to the far left(X=0), then full forward(Y=0) and then to the middle of the bed(X halfway,Y halfway) where it...
From the position of the T in the triangle is could be a 1.1 or a 0.0.3 (though a "v0" should be visible below). So my guess would be the...
Rightmost in the diagram is S0, so `S0 S1 S2 S3` is `11 6 5 4` for 1.0 and `5 6 4 11` for 1.1 That does not match, but...
Does the printer still react to commands via USB? Question is whether the display itself freezes, the mainboard/firmware or the serial communication between both. Could be anything from a firmware...
@bhamail any chance to get some PRs released? I'm running a build including this fix, #165 and #167 in 2 instances since early October (Nexus 3.72 to 3.74) without any...
The question is, what would we expect in such case? `scandir` fails, in other words we cannot determine the contents of a (sub)directory. Guess it’s likely to expect that we...
> The cron doesn't even check if the setting is valid at all. I'd consider this a minor flaw. We do sanitize the options during update and only accept numeric...