KT36SSVPR-GPIF5- Testing

[ajo79]

Hello all,

I am using the git source code - https://github.com/stancecoke/BMSBatter ... _firmware In this code, there is one java tool "OSEC Parameter Configurator", by which we can set the parameters (which will update config.h file in the source code). I didn't get the "proven setting" .ini file for the controller model -KT36SSVPR-GPIF5 In this .h file, why do we have 3-speed limits?

#define limit 6 #define limit_without_pas 6 #define limit_with_throttle_override 6

Where can I get this ini file?

Also, I downloaded the program using the below config.h file.

By default, the Assist level speed limit is 6km/h. but the actual speed I am getting is 72 km/h(when I pressed LCD-3 down button). (motor is in noload condition) Please guide me in the testing of this controller

/*

• config.h
• Automatically created by OSEC Parameter Configurator
• Author: stancecoke */

#ifndef CONFIG_H_ #define CONFIG_H_

#define NUMBER_OF_PAS_MAGS 8 #define limit 6 #define timeout 3125 #define wheel_circumference 2040L #define limit_without_pas 6 #define ADC_THROTTLE_MIN_VALUE 50 #define ADC_THROTTLE_MAX_VALUE 185 #define BATTERY_VOLTAGE_MIN_VALUE 116 #define BATTERY_CURRENT_MAX_VALUE 150L #define PHASE_CURRENT_MAX_VALUE 500L #define REGEN_CURRENT_MAX_VALUE 0L #define MOTOR_ROTOR_DELTA_PHASE_ANGLE_RIGHT 237 #define current_cal_a 100 #define LEVEL_1 30 #define LEVEL_2 45 #define LEVEL_3 60 #define LEVEL_4 80 #define LEVEL_5 100 #define MORSE_TIME_1 50 #define MORSE_TIME_2 50 #define MORSE_TIME_3 50 #define RAMP_END 1500 #define P_FACTOR 0.5 #define I_FACTOR 0.1 #define GEAR_RATIO 44L #define PAS_THRESHOLD 1.9 #define RAMP_START 64000 #define limit_with_throttle_override 6 #define CORRECTION_AT_ANGLE 127 #define DISPLAY_TYPE_KT_LCD3 #define ANGLE_4_0 1 #define ANGLE_6_60 43 #define ANGLE_2_120 86 #define ANGLE_3_180 128 #define ANGLE_1_240 171 #define ANGLE_5_300 213 #define TQS_CALIB 0.0 #define ACA 128 #define EEPROM_INIT_MAGIC_BYTE 132 // makes sure (chance of fail 1/255) eeprom is invalidated after flashing new config #define ADC_BATTERY_VOLTAGE_K 70 #define ACA_EXPERIMENTAL 128 #define BATTERY_VOLTAGE_MAX_VALUE 155

#endif /* CONFIG_H_ */