beepy-hardware
beepy-hardware copied to clipboard
sqfmi
Beepy Hardware
It would be fun, to add gpio header from rpi set up to plug LTE module like this: [Simcom A7670E](https://a.aliexpress.com/_EyDOYEZ) Or this [Simcom A7670C which seem to be smaller](https://a.aliexpress.com/_EG3nBLJ) Or...
When I print the case of nylon, it breaks. The producer suggests 2mm for the case of nylon, and 1.5mm for PLA and resin. 
I was able to use a piezo element to get my beepberry to speak using espeak. It would be nice if the next rev of HW had a buzzer/piezo for...
I want to make a shield like PCB for the side expansion I/O. Unfortunately the pins would interfere with the SDCARD/MIPI jacks. I don't care so much about the MIPI...
Here's a list of things that I've found while doing (a little bit weird) bringup for supporting my [mnemos](https://github.com/tosc-rs/mnemos) project. * [ ] The display VCOM toggle pin is connected...
I like the sharp display, but it would be awesome if you could choose between it or a color alternative. Maybe you could make the displays sit on carriers, so...
It would be awesome if you could choose to use either rpi zerow or a CM4 module. Maybe you could make a conversion carrier? The volume seems to jive. I...
I'm not sure how you'd package it, but it would be neat to integrate a LoRa transceiver in the next version of the board. You could use it to send...
I like that you broke the extra I/O out for expansion. Mechanically though, I'd like to see it consolidated into single stack able header. I'd also switch from through hole...
I'm a fan of filling with ground plane. In v2, I think you should fill both sides with ground plane. If you did that, you could flip the RPI over...