Thanks. How does calibration work please ?

[allotmentearthy]

Hello, Wonderfull stuff. Thanks

I can make it work. Out of factory readings are very far from 220V So I changed vgain

Nevertheless I saw there was a calibration command What are the units of vtarget and itarget ?

Start EMeter Calibration{"emeter" "start_calibration" "vtarget":13462,"itarget":16835}}}

I am guessing the two values should be those known from a device that does draw vtarget volt and itarget amps exactly ? And then vgain and igain would be set automatically ?

Example above is confusing since 13462 is the same value as vgain value in ´´the manual´´, and 13462 is like 1.3462 that is a diviser to adjust the voltage

Thanks

[Zibri]

I am also interested in this. Anyone?

[Zibri]

About 220v.. usually the real voltage of outlets it's between 230 and 240... mine here is 227.. but in other places is as high as 235