homebridge-knx icon indicating copy to clipboard operation
homebridge-knx copied to clipboard

Published 20 hours ago • verified publisher icon snowdd1

Help with shutter control please

Open pipa2493 opened this issue 6 years ago • 6 comments

Hello. please tell me what design should be used, and it is already confused... I have no feedback from the motor.... 2/0/0-telegram 0 (close), telegram 1 (open) 2/0/1-stop default

pipa2493 avatar Dec 12 '18 17:12 pipa2493

What is the third line in the picture?

snowdd1 avatar Dec 13 '18 08:12 snowdd1

1 byte is the value for the position of the curtains, but do not use it because there is no feedback from the motor

pipa2493 avatar Dec 13 '18 17:12 pipa2493

use 1 bit to control. Is it possible in homekit?

pipa2493 avatar Dec 13 '18 17:12 pipa2493

No. You need to specify the run times in ETS for your motor, so the actuator control can calculate run times to percentages.

snowdd1 avatar Dec 14 '18 10:12 snowdd1

Ok. Thanks. What about feedback?

pipa2493 avatar Dec 14 '18 10:12 pipa2493

For my GIRA actuators I can activate a feedback object that provides active feedback on the position the same way. So you have a set and a listen address. Look at the parameter configuration of your actuator.

snowdd1 avatar Dec 14 '18 11:12 snowdd1