katana-midi-bridge
katana-midi-bridge copied to clipboard
snhirsch
Provides enhanced MIDI control capability to Boss Katana (tm) guitar amplifiers
I have a bt-200s-6, trying to use it with this amazing code, but im a newbie to python and linux in general, so i dont know how can i map...
GPIO
Could it be used with a Raspberry Pi and GPIO instead of midi? Might be nice to make a pi based footswitch like the GA-FC that plugs into the USB...
does katan-midi-bridge force me to use an extra midi controller? I am hoping to get this set up on my pi and use strictly the pi to control my katana...
Hi there, I'm late to the game but I recently acquired a BBG and followed the guide for installing the bridge software. I got it going last night. First let...
The install seems to go fine, but when i follow the steps through to the "Show_Interfaces" command, the last line beginning with 'USB' is missing from the output as shown...
Hi There So far i have tried this on 3 RPis and managed to get one to work but the lag was about 4 or 5 seconds so unusable in...
Hi snhirsch I can get the boss gt-10 to control one boss katana (..with the same issues as described in https://github.com/snhirsch/katana-midi-bridge/issues/9) - but i have two katanas 100/212 and would...
Hello, Sorry I don't know if it's the right place to ask this question. But your software is just amazing. I use for live audio Ableton Live and I will...
Hi, thanks for this great utility! I've got the volume control working, but not save/restore patches when using a boss gt-10. Looking at the midi data it outputs it sends...
I found the patch addresses: `.. .. 12 15` `.. .. 12 16` These are not listed in your .txt file yet. They allow you to set for each knob...
