Arilux_AL-LC0X
Arilux_AL-LC0X copied to clipboard
smrtnt
Alternative firmware for Arilux AL-LC0X LED controllers, based on the MQTT protocol and a TLS connection
I have a few of these and I'm likely to buy more... I also have a bunch of esp8266 units of other flavors. Hooking up a WS2812 strip to them...
Allow light to be controlled (on/off) from the wall toggle switch for the backwards compatibility with non-geek family members. Had to do this to meet minimum [WAF](https://en.wikipedia.org/wiki/Wife_acceptance_factor). Have simple working...
I'd like to request a feature so that when I turn off the device it fades into black with the specified `transition` duration. For example: `{ "state": "ON", "transition": 3...
It would be nice if the device could remember the last color set, eg.: by storing it in its EEPROM so that the next time I plug it in it...
ESP8285
I've ordered a AL-LC03 on bang good. After opening it and trying to identify which pin I've to connect to flash firmware, I've noticed that the wifi chip is not...
I'm trying to flash a v1.4 board, but I can't get it to boot in flash mode. I have it connected up as follows: FTDI Board Rx --> Tx Tx...
[This is quite cool](https://github.com/tzapu/WiFiManager).
I need some help with DEBUG_TELNET. 1. I enabled it in config.h and uploaded the new firmware. 2. Checked the IP address of the device in my router's DHCP list...
Under paragraph MQTT. chapter one it states: "For example, if you wanted to turn the light on, set it to full brightness, and make it red, you would have to...
Hi, I think your project is great but it would be even greater (I think) if it was part of the ESP Easy community. Would you consider converting this to...
