Slic3r
Slic3r copied to clipboard
Unexpected solid layers on slopes
I am seeing extra solid draws under and over slopes. It appears to be dependant on the angle of the slope. Bug_Report_1.zip
Steps to reproduce the behavior: Load the included model and config. Preview the slice and go to the layer view. Use the slider to view somewhere around the middle of the model. Note the extra solid draw near the sloped walls. This is unexpected.
- OS: Linux, Fedora 32
-
- Version Slic3r-1.3.1-dev-c61c25b-x86_64.AppImage
Does not seem to depend on the infill value. Tried 1%, 5% (shown), 15%, and 50% and noticed no variation.
https://github.com/prusa3d/PrusaSlicer/issues/1054
https://github.com/prusa3d/PrusaSlicer/issues/668 https://github.com/supermerill/SuperSlicer/issues/253
https://github.com/slic3r/Slic3r/issues/4496
https://user-images.githubusercontent.com/10374140/111192555-91ed5600-858f-11eb-97e4-795aee3443a7.mp4
I produced an animation from a series of screenshots showing the bottom few layers. It starts just above the last solid bottom layer and goes until it reaches 'steady state'.