Eachine-E011
Eachine-E011 copied to clipboard
silver13
My E011 won't bind
I've been troubleshooting it for quite some time now, but the issue persists. After a crash, head down, it won't bind no matters what I do.
I've tried to bind it with a stock transmitter, and a multi protocol plugged in my Flysky transmitter. I also flashed the regular, acro only, and factory firmware. Nothing worked.
I appreciate any help. Thanks in advance.
Maybe check that the antenna is still attached?
-------- Original message -------- From: LamG4 [email protected] Date: 7/20/18 11:02 (GMT-05:00) To: silver13/Eachine-E011 [email protected] Cc: Subscribed [email protected] Subject: [silver13/Eachine-E011] My E011 won't bind (#12)
I've been troubleshooting it for quite some time now, but the issue persists. After a crash, head down, it won't bind no matters what I do.
I've tried to bind it with a stock transmitter, and a multi protocol plugged in my Flysky transmitter. I also flashed the regular, acro only, and factory firmware. Nothing worked.
I appreciate any help. Thanks in advance.
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHubhttps://github.com/silver13/Eachine-E011/issues/12, or mute the threadhttps://github.com/notifications/unsubscribe-auth/Ade1I7h8FghUT8l5HbNDowXwdUPgXZ7iks5uIfDsgaJpZM4VYLn4.
Sounds like you may have broken your crystal oscillator. Read this page, there are a few relevant comments: https://www.rcgroups.com/forums/showthread.php?2868518-Eachine-e011-Review-Mods-and-ACRO%21%21%21%28always-in-construction%29/page49
Yes the antenna still attached. It shouldn't be a problem even if I broke off the antenna because my transmitter is right next to it.
I checked the crystal oscillator and it's still attached, if it's the tube like thingy I thought it was. It'd be great if you know the part number so I can get a replacement to try on. I closely inspected everything and it looked like the board is fine.
it's not always broken on the outside, it's a 16Mhz crystal, you could use one from a tx to see if it is the crystal, it's larger but should still work.
they can be found on ebay
Confirmed it was the crystal. I replaced it with a crystal from my sacrificial E010 board and now it binds just fine. One more problem is that it kind of take some time to bind. The lights turn on dim for a good 4-5s before it goes into bind mode.