Shawn Chronister

You can't the CB1 does not support DSI. PI4adapter is not the problem you can order a CB2 or CM4 module and DSI will function.

Ok I am not sure what you are talking about there site clearly shows the PItft43 only working with DSI.

After it booted on my network I had to remove power and plug it back in again for it to actually connect. Does you wifi name have space in it?

Did you try removing the power and power it back on after a fresh install I always had to do this to pull an IP.

The ethernet LEDS do stay on currently when even connected to wifi on mine as well hopefully that get corrected in the future. BUt I am still connected to wifi.

@RPK3D if you can reimage with a fresh load and connect it via ethernet You have to wait for all lights to stop and unplug and power back up before...

AnAwesomePos yep Thats where I am and I am fighting to get it replaced with tech support I have a big post on the facebook group might want to luke...

It not the antenna I was right next to my router and it will not connect

Thantik went back to an unsupported image. No I did not because I have successfully configured the current image and it works if you follow my steps unless there is...

> > So @shawnchr's hotfix helped a bit to make it work. > > I still had to change my wireless connection via "sudo nmtui". The CB1 tried to dial...