shadowano

I don't have prices. In my initial post I had big problems getting the UI up in wifi mode, but not in AP mode. Sometimes the page didn't load, sometimes...

> Could it be that it actually is rebooting very often? If you try having USB power on it at all times, is it then stable? I already have on...

The reported problem happened again yesterday, and I have still not got it up and running longer then for a few seconds. I saw that my mesh system showed red...

I got it up again after turning off power for both mesh router and internet modem for a few minutes, and after they got online I rebooted amsleser, and after...

Internet was shortly down again just now, and ams leser reports a software reset reboot in the same time period. But it managed to recover again when Internet was back...

This is a recurring issue for me, I have a hard time finding the cause. but as I have reported earlier in this thread the amsleser is non-responsive when trying...

I put the amsreader into AP mode again, and removed the MQTT ip address, saved and rebooted. Now the UI is responsive again. It has been up for 20 minutes.

> Any particular reason you did that in AP mode? You should be able to do that directly on the Config page. I know that I can do that, but...

I rebooted the amsleser manually from the HW button, after a few seconds it came up and started sending data to Home Assistant over MQTT. Less then 60 seconds after...

If I stop the MQTT broker I have in home Assistant the amsreader is totally unresponsive. The browser cannot reach amsreader interface at all. @ArnieO could you try to do...