sfstar

Hello @FcoCalero, Do you mean the home assistant built in energy dashboard? I.e. this: In that case the sensors should be available in the energy dashboard configuration section. I.e. this...

Hmm strange. This is what I see when I try to add another battery system: It seems that I can't recreate the observed behaviour on my end. Could you share...

It seems that only the system device (unit 100) was detected during the last scan. Unit 100 doesn't have any kWh based entities that it exposes to home assistant. Tthe...

So I might have found the cause for your issue. Your screenshots show that you are running the following firmware versions: GX: v2.84 multiplus: 481 While i'm running: GX: v2.92...

No problem, thank you for confirming that a firmware upgrade solved your issues. For now i'm going to leave this issue open until an implementation / decision is reached on...

Hello and thank you for opening this issue. If you are using a CAN.bus BMS than the following applies for the entities that are 0: `Not supported by CAN.bus BMS...

The Vebus entities seem to be the only registers available that provide charge/discharge information when using CAN bus connected batteries. Currently I'm still waiting on a can bus BMS that...

Hello and thank you for opening this issue. I believe victron added new registers with a larger datatype containing the exact same information to prevent this issue. introduced in one...

Will add this to an upcoming PR

Hello and thank you for opening this issue, Model 0 should not contain settings entities. You can safely disable/delete those (leave other model 0 entities untouched however). Will need to...