Check Cell Message

[Kranzy]

Hi @sfeakes

My cell has ticked over the 6000hrs now and is currently showing a message on the SWG displaying 'check cell'.

I haven't seen anything in the docs in aquapured or aquarited that shows this message.

Is there something I can do log wise to see if this data can be read by aquapured? Ill will avoid reseting the hours to remove the error until I hear from you.

Thanks Paul

[sfeakes]

MQTT fullstatus should show check cell message. #8 is check cell, this is the same as clean cell.

https://github.com/sfeakes/AqualinkD/wiki#MQTT

If your not seeing that, can you post the serial_debug logs from AquPureD.

[Kranzy]

noticed in v0.5 onwards the log location is not in the config file anymore. Whats the process to get the serial debug log you need for this? Ill do this before updating to the latest release.

[sfeakes]

Thanks for catching that, the code is there, just forgot an example entry in the config file.

LOG_FILE = /dir/file.log

[Kranzy]

Hi @sfeakes

See attached log.

First part showing no flow was because I didn't turn the SWG on for a while. You'll see the turn on msg, no flow for a little while then generating. The whole time the SWG was on the display was flashing check cell. As I mentioned before it is because the cell hit 6000 hrs run time.

The cell looks in good condition, however I might clean it anyway to see if that's the reason that I am getting a different salt PPM reading between the cell and the tested water. I'll report that in the other issue.

Let me know if you need anymore information. Ill wait to hear from you before I clear the message on the unit.

Aquapure-v0.5.log

[Kranzy]

Just to update I reset the cell counter today, however AquapureD never showed check cell in the fullstatus.