Serge

@fadi9711 unfortunately light bar is not covered in 4-zone RGB settings command that is available, so that's normal :) I assume it works as expected now. Thanks for checking

@fadi9711 for some (older) models 4-zone covers light bar :) For a newer model it doesn't unfortunately. For the "fan", as soon as you apply either custom fan curves or...

@fadi9711 then it's just how firmware handles manual mode :) It's not G-Helper turning fans on or off in realtime.

@fadi9711 modes and all (optional) custom settings are applied every time you select them, or change. Each time you re-apply mode, firmware may change fan behavior (re-init them). It will...

@Nick-Prism hello, does it work if you set it using Armoury? Did you try doing EC-reset as explained in Troubleshooting?

@Nick-Prism any updates here ?

@Nick-Prism glad to hear. Battery health is taken from windows, it constantly recalibrates it based on charges / discharges. It's likely just due to a reboot or so :) Thanks

@AleITDE1990 hello, sorry for a slow response - I was away :) G-Helper's AutoTDP is very straightforward. App uses only "official" (i.e. Armoury's) power limiter to set TDP. It is...

As discussed in https://github.com/seerge/g-helper/pull/3635 EPP doesn't seem to have any real effect, so it doesn't make much sense to overcomplicate things :)

@AllehBarros hello, I was answering this few times For example here https://github.com/seerge/g-helper/issues/4155#issuecomment-2922752526 or here https://github.com/seerge/g-helper/issues/3500#issuecomment-2556639193 It's not possible due to how controller is implemented on Ally