Wolle

It will be weeks before an HMI display works properly here. A display that is well suited would be the one from Elecrow https://www.elecrow.com/esp32-display-5-inch-hmi-display-rgb-tft-lcd-touch-screen-support-lvgl.html. But make sure that you don't...

Hello, basically any display is suitable that has colour inputs (8 each for red, green and blue), control lines for horizontal and vertical synchronisation, a clock and a control input...

This is exactly the display I used. https://wiki.makerfabs.com/Sunton_ESP32_S3_5_7_inch_IPS_with_Touch.html Unlike an SPI display, it is not necessary to initialise the TFT controller or change the gamma values. But it is not...

Please have a look at the V4 pre-release branch in the readme. There is a schematic diagram there. The use of the pins depends on the display. With the ESP32-S3,...

If you want to use this display, (almost) everything can remain as it is. The red GPIOs are for Flash and PSRAM and cannot be used. The two red marked...

DMA is required for I2S and also for the buffer that contains the image for the display. If you activate MCLK, the image is no longer synchronised.

It's hard to say, I can't test all the displays that are out there. I have a Waveshare 7 inch display with additional ICs for CAN bus, RS485 and I2C...

Hello @valera39, I have added AMP_ENABLED. If you have a Sunton display you can use GPIO10 for it. This is intended for SD_CS, but is not used. However, you must...

I have adopted the sdkconfig from V2. But somehow the settings have been reset. Now it will be okay.

Your reception field strength of -56dB is very weak. BT and WiFi use the same band, BT performs "frequency hopping" to occupy a different channel. Try to position the BT...