schm0

Bitrate seems to change now when adjusting the qvbr-quality value. I'm not sure if your updated version or the newer drivers did the trick. //edit According to this doc: https://github.com/GPUOpen-LibrariesAndSDKs/AMF/wiki/Rate%20Control%20Methods...

eduperez is right. The only change in this repo is the firmware for 88W8864. Forked Repos can't be made private. The firmware was extracted from the official Linksys firmware. However,...

Hi! Can you check the arp tables on the clients? On my wrt1200 with 802.11w enabled arp broadcast are not delivered after some time. But im also not sure if...

Actually on my system this does not work. It tries to load the firmware but later in the log it states that it failed. I have to build the firmware...

You can add an ipv6 route by yourself in /etc/config/network Something like: ``` config route6 option interface 'wgc0' option target '::/0' option metric '256' option table 'pbr_wgc0' ``` Adapt interface...

Without a proper route this obviously can't work. PBR copies the routes already in place. For WAN/WAN6 this is no problem because there is usually already a "catchall" default route...

Can you explain what your intention with this change is? Going through all that code is a bit much. `|| ipv4_error=1` this should be ipv6_error=1 ? I'm trying to figure...

Requiring Numpy 2.x for Python 3.9 makes it incompatible with older Tensorflow versions.... tensorflow-intel 2.17.1 depends on numpy=1.23.5; python_version

> > [@Conan1231](https://github.com/Conan1231) if you are referring to this jellyfin plugin, it's now available by just searching for it on the LG store thingy, developer mode isn't necessary anymore! >...

h265 works fine on my device?