runesmdk
runesmdk
Pun intended. Rolling cut of just 1 event per cycle is too little. On a 4 cylinder, it should happen over a total of 5 ignition events, 4 should cut,...
Add VSS to launch; Add a setpoint for which, if all conditions are met, launch is active below set vss. Make it so it is only enabled with a tick-box,...
Trigger contains both speed and home signal. Possible to make it sequentially capable? Would love to do away with my old rotorbutton and rotor cap :)
Like jmunkdk - i'm experiencing strange basic distributor behavior. (https://github.com/noisymime/speeduino/issues/169) The problem is not upon starting as such, nor is it running, but if the engine stalls, or the crank...
Let the rpm for launch be either locked to a number as it is now, or configurable to lock onto current rpm. (Can be so activating launch below x rpm...
Board crashes and looses comms (fail to burn page) if set to daihatsu 4cyl trigger using c5 cam1/hall1 input.
Straight from jlcpcb, is crankshaft then ready for vr or hall? What mods to swap sensor type on crank? And same for cam, what sensortype, and what mods to swap...
Like the rpm-taper, is it possible to add a load-axis taper (map or tps)? Driving with throttlebodies and having the injectors somewhat away from the cylinderhead makes the fuel behave...