rtrout

> You should start with the examples.2.scad file, as listed in the instructions. If you just want a minimal box, then example_mmu.scad works as well. The code you have listed...

I'm also experiencing this problem. Have only recently added this plugin, so my first time attempting export. I note the plugin calls URL: /plugin/PrintJobHistory/exportPrintJobHistory/CSV It appears to just timeout. Anywhere...

Ok, my github detective fu is poor. This version of printjobhistory is abandoned, https://github.com/dojohnso/OctoPrint-PrintJobHistory is the latest fork but also abandoned, but probably where this issue should be reported (if...

Came here because of the community mention. I've noticed this frequently. My workstation is well away from my printer, so frequently end up in this situation. Noting that it doesn't...

I've started getting this problem too. Only noticed it recently, not sure how long it's been happening and what might have triggered it :-( I have been experimenting with plugins,...

As indicated in the gcode filename, prusaslicer estimated at 3h30m, which is roughly correct. As you point out ptg calculated at 6hrs. Not sure when this started happening, only that...

This is what M503 reports for me. The feedrates seem to differ for stealth, which I don't use. Is there something I'm missing? If I want PTG to 'reload' the...

This is what M503 reports. I don't understand to to tell PTG to 'reread' from M503 to make sure it is using current settings? Send: M503 Recv: echo:Steps per unit:...

I'm guessing this may have been introduced by firmware 3.14.0 - the timing would be about right. Dumb question, how do I run marlin-calc with the regular mode parms? Looking...

Ok, thanks for the pointer, found the call to marlin-calc, and as you anticipated, it is using the stealth parms, presumably because M503 is report stealth mode parms AFTER normal...