xbee-comm by Joshua Roys [email protected] patches for macosx support by Bernard Pratz <guyzmo{at}leloop{dot}org>

git://github.com/roysjosh/xbee-comm.git https://github.com/roysjosh/xbee-comm irc://irc.freenode.net/#xbee-comm

Build instructions: xbee-comm$ autoreconf -vi . xbee-comm$ ./configure xbee-comm$ make

In order to access the xbee as a regular user, you could do the following:

setfacl -m u:$USERNAME:rw /dev/ttyUSB0

On MacOSX, please use /dev/cu.usb* instead of /dev/tty.usb* to access the serial device where your XBee is plugged into.

Firmware files can be downloaded from digi: http://www.digi.com/support/productdetail?pid=3430&type=firmware ftp://ftp1.digi.com/support/firmware/

If you had a Series 2 XBee, you could do something like the following: $ wget http://ftp1.digi.com/support/firmware/82001817_F.zip $ unzip 82001817_F.zip $ xbfwup [args...] ebl_files/XB24-ZB_21A0.ebl Entering AT command mode... Entering bootloader... ..... Beginning programming... Read 100224 byte firmware file (783 blocks). .................................................. 50 .................................................. 100 .................................................. 150 .................................................. 200 .................................................. 250 .................................................. 300 .................................................. 350 .................................................. 400 .................................................. 450 .................................................. 500 .................................................. 550 .................................................. 600 .................................................. 650 .................................................. 700 .................................................. 750 ................................. Waiting for upload confirmation... Programming complete, running uploaded firmware...