Rory Allen

That's actually a very good point that completely slipped my mind. I had been in the mindset of wanting to make everything as big and spaced out as possible but...

I reckon that's a good call! I might make it an alternate panel that has extra jacks/knobs as I really want this to not take away any I/O that people...

As suggested by @mjaskula, the current design now uses smaller tactile switches for the bootsel and reset functions to try and prevent accidental presses 

> Could the spoof have a 2x10 pin header to allow for a common cable (assuming they are made)? That is actually a great idea; even better (more standard) would...

That is a very good point. There should be quite a lot of spare room around the connector if it is the full size of a Pico though, so perhaps...

That's a good example, this one should be even less easy to confuse too, as the expander one would be 16 pin on both ends, whereas power is only 10...

That's definitely something I'll keep in mind, probably for a separate expander though as I'd rather leave as much up to the user as possible, and they might not want...

This looks great, it's a much nicer way of looking at all the scripts than the Discord channel (to be honest I think I will delete the channel once this...

> What are the exact resistors that need to be replaced? > Would you need to add an additional over voltage protection? > Of you change them to 39k resistors...

Sorry it's been so long since I looked at this. Just tested again and found a few things: In lcm() there is a chance of a divide by zero, I'm...